• Coil springs for Defender 90 , 110 and 130, Discovery 1, Discovery 2 and Range Rover Classic 
• 110/130 Heavy load rear springs
• 110/130 Light load rear springs
• 110/130 Medium load rear springs
• 90/D1/D2/RRC Heavy load rear springs
• 90/D1/D2/RRC Medium load rear springs
• D2 Heavy load front coil springs
• D2 Medium load front springs
• DEF/D1/RRC Heavy load front springs
• DEF/D1/RRC Light load front springs
• DEF/D1/RRC Medium load front springs
• Defender 1 inch lowered springs
• Defender 2 inch lowered springs
• Defender Standard Height Springs (Heavy Load)
• P38 Coil Springs

TERRAFIRMA COIL SPRINGS

 

The purpose of a vehicle’s suspension is to support
the weight of the vehicle and absorb impacts,
maximising the tyre’s contact with the ground
while maintaining stability and control.

 

When using a Land Rover off-road the limits of the standard
suspension are quickly realised when the lack of
wheel travel affects traction and ultimately the
vehicle’s ability to maintain forward motion.

 

The added benefits of long travel suspension are
exponential. Taller suspension allows larger tyres
to be fitted as well as allowing greater suspension
movement. Raising the suspension will also
increase approach, departure and ramp over angles
allowing your Land Rover to overcome larger
obstacles.

 

Terrafirma Coil Springs are designed to lift the
vehicle by approximately 2” (50mm).This is
the optimum increase in ride height before the
mechanical limitations of the suspension design
become an issue requiring further modifications.
Safety has to be a consideration, raising the centre
of gravity too high increases the risk of a roll over.
A vehicle lifted by 2” (50mm) using correctly
matched Terrafirma Coil Springs and shocks will
also improve on road handling, comfort and stability from the original set up.

 

Terrafirma Coil Springs are made from the highest quality steel, formed on accurate computer controlled mandrels and precisely heat treated to ensure consistent manufacture. All springs are shot peened to relieve stress and scragged to ensure long spring life and prevent sag, finally powder coated silver for long lasting good looks.

 

Correct Coil Spring Selection

 

It is important to understand that all Terrafirma Coil Springs have been designed to provide approximately 2”  (50mm) of lift while carrying light, medium or heavy loads. Minimal mechanical changes are required when lifting by this amount, however the Terrafirma Hardware range of accessories does allow for greater lift and significantly increased wheel travel, further enhancing off-road ability.

 

Selecting the most suitable springs for a Land Rover may be with some compromise. A heavy load spring needed when fully loaded may ride too high and too hard when unloaded. Likewise a light load spring that is comfortable
and flexible will not achieve the desired lift or carry the heavy loads associated with expedition vehicles.

Load carrying coil springs are often progressive or variable (V) this provides a combination of comfort and load carrying in one spring.

 

It is worth noting that Terrafirma coil springs are sold in pairs, in many cases one spring is 10mm longer than the  other, the longer spring should always be fitted to the driver’s side.

 

By considering the three Defender images and combining the Terrafirma Coil Spring application guide and specifications it should be possible to select suitable coil springs or a suspension kit for your vehicle. Use the detailed spring descriptions by part number to help accurately fine tune the spring requirements for your specific application.